As we all know, LVT stands for Luxury Vinyl Tile and is known for being the flooring of choice for commercial designers and industrial renovations. Therefore, with the development of society, more and more homes and corporate bathrooms are using lvt bathroom flooring. This article will take you through the adhesive installation of lvt bathroom flooring.

1. lvt bathroom flooring adhesive installation basic requirements.

(1) the grass-roots levelness 2m range of high and low fall, not more than 2mm;

(2) concrete or cement mortar compressive strength of not less than C20 (20Mpa), maintenance period greater than 28 days; surface hardness greater than 1.2Mpa;

(3) The moisture content of the grass-roots level (LVT resilient flooring) does not exceed 4%;

(4) The combination of levelling layer and its next layer should be solid. There should be no hollow drum, cracking, sand, honeycomb and other defects;

(5) The ambient temperature during construction is 10℃~30℃, and the air humidity is 35%~75%, avoiding cross-construction;

(6) the most suitable ambient temperature is 15℃~25℃, and air humidity is 45%~60%.

2. lvt bathroom flooring adhesion installation grass-roots treatment method.

(1) the use of a grinding machine overall grinding ground, remove the isolation material, and use a vacuum cleaner to clean up the ground dust;

(2) detection of grass-roots levelling, 2 meters check ruler 2mm height difference for qualified grass-roots level, beyond and need to levelling treatment again, levelling materials generally choose cement-based self-levelling materials;

(3) self-levelling dry solid finish before paving LVT floor must be self-levelling surface grinding treatment, remove the self-levelling surface floating slurry, revealing a dense and clean surface.

3. lvt bathroom flooring paving.

(1) lvt bathroom flooring into the construction site, in compliance with the indoor temperature conditions, each box of flooring flat on the grass-roots level to be paved resting for more than 24 hours (commonly known as floor regeneration) according to the design drawings, colour texture corresponding to the floor model laying;

(2) plan a good floor module, pop out the vertical cross-positioning control line, following the parquet pattern or texture direction order gradually implement pre-paving;

(3) according to the grass-roots situation and the floor backing structure to choose the appropriate scraping tooth bar, cement-based self-levelling grass-roots level to choose A2/A3 scraping tooth bar;

(4) lvt bathroom flooring should be installed using the prescribed floor adhesive adhesion. The key technical indicators in the glue are the basic condition to ensure the perfect paving and installation of the LVT floor;

(5) adhesive should be evenly scraped in the lvt bathroom flooring paving area. The glue to dry to the drawing state can be used for paving the floor;

(6) each scraping glue area needs to ensure that the lvt bathroom flooring is sticky within the construction time, do not scrape a large area of glue, scrape the good glue body a long time to dry glue, beyond the glue "construction time" and then paving lvt bathroom flooring, will lead to lvt bathroom flooring paste failure;

(7) can be constructed according to the environmental temperature and humidity, grass-roots absorption and change, the adhesive loses the ability to transfer that is the end of the construction time;

(8) floor paving should be used after the completion of the cork push board exhaust, again using iron pressure roller rolling or multiple rolling. (Iron pressure roller specifications are generally 50 kg, 80 kg) lvt bathroom flooring sheet edge needs a handheld small pressure roller for rolling;

(9) floor edge contaminated adhesive with a moist rag to remove in time.

The above is about lvt bathroom flooring adhesive installation. If you need more detailed information, welcome to contact us!